Training

ECU repair and cloning course

For those wanting to build or expand a laboratory: open an ECU, diagnose the electronic fault, replace the component, and when there is no repair, clone it to another unit. Soldering, schematics, laboratory tools and plenty of practice on real units.

Soldering components on an electronic boardECU repair and cloning course · Zaragoza

Key facts

Category
Training
Format
In person in Cuarte de Huerva · live online
Typical lead time
1–2 days
ECU access
—
Support
Included · 8:00–22:00 every day
Price
Fixed quote in under an hour

01

Which ECU faults do you learn to repair?

You learn the common faults by family: burnt injector drivers on Bosch EDC, voltage regulators, capacitors and transistors in the power stage, tracks damaged by moisture, corrupt EEPROM and communication problems; you practise diagnosis with schematic and oscilloscope, SMD replacement and subsequent bench testing.

An ECU repaired for €40 of components versus a new one at €800 plus coding: that is the laboratory's business. The course teaches knowing when it is worth it and how to do it with guarantees.

02

How is an ECU cloned and which tools are used?

It is cloned by reading the flash and EEPROM of the original unit (even if partly failing) on bench or boot with FLEX or Hexprog and writing them to a replacement unit of the same hardware, then checking on the bench with an immobiliser emulator that it starts and communicates; the course covers procedures by family and the traps (versions, protections, Tricore).

Tools under Magic Motorsport FLEX and Hexprog; emulators under CarLabImmo. Related service: cloning.

Comparison

Repair and clone in your laboratory vs. send to ASF Tech: which is right?

Quick answer: Sending units works for low volumes; building a laboratory with training pays when the workshop receives several ECUs a month or wants to offer the service to other workshops.

CriterionOwn laboratorySend to ASF Tech
InvestmentTools + trainingNone
Lead timeHours2–4 days
For whomSeveral ECUs a monthOccasional cases
SupportOurs, after the courseIncluded

Start by sending. When volume justifies it, the course and the tools.

FAQ

Frequently asked questions

Do I need to know how to solder?

A base is advisable; SMD is practised during the course.

Which tools do I need afterwards?

Soldering station, PSU, oscilloscope, FLEX or Hexprog, emulator. We advise as dealers.

Are clusters and airbags covered?

Introduced; the focus is engine ECU and TCU.

How many places?

Four per edition.

Contact

No-obligation quote for ECU repair and cloning course

Tell us the vehicle, engine, ECU and what you want to achieve. We reply during support hours with a fixed price and lead time.

Request a quote

Data controller: ASF Motors SC (ASF Tech). Purpose: to answer your quote request. We do not share your data. You can exercise your rights as explained in the privacy policy.

Last updated: