Engine performance and response

Eco: remapping to save fuel

Eco does not chase peak power: it brings torque forward at low revs, smooths delivery and optimises injection in the zone where a van or truck spends 80% of its time. The result is 5 to 12% lower real consumption and fewer gear changes.

Petrol station lit up at nightEco: fuel saving · Zaragoza

Key facts

Category
File service
Format
File for workshops · in person in Zaragoza
Typical lead time
15–60 min during support hours
ECU access
OBD, bench or boot by ECU
Reversible
Yes, original kept
Support
Included · 8:00–22:00 every day
Price
Fixed quote in under an hour

01

How does an Eco remap save fuel?

The Eco remap increases torque between 1,200 and 2,500 rpm so the engine moves the load at lower revs, optimises injection quantity and timing at part load, smooths pedal response to avoid injection spikes and, on automatics, allows earlier shifts; the driver uses less throttle for the same work.

The saving comes not from magic but from making the engine work in its efficient zone. On a delivery Transit doing 200 km a day, 8% is about 1.2 litres a day and over 300 a year per vehicle. On ten-van fleets the file pays for itself in weeks. We always ask for measurement with the same driver and route before and after to give the manager an honest figure.

02

On which vehicles does Eco work best and where does it not pay?

Eco works best on turbo diesel vans, light trucks, buses and high-mileage cars that run loaded or in town; it pays less on naturally aspirated petrols and drivers who already run at very low revs, and it is no substitute for poor maintenance (saturated DPF, injectors, filters).

For fleets we offer a plan: measurement on two or three pilot vehicles, report and rollout to the rest with the fleet's workshop or with us. On vehicles with AdBlue or DPF problems, the manager usually combines solutions; we handle it case by case.

Comparison

Eco vs. Stage 1: which file for a working van?

Quick answer: Eco prioritises low torque and consumption and suits loaded working vehicles; Stage 1 prioritises maximum power and is for those who want performance; both can be combined in an intermediate file.

CriterionEcoStage 1
GoalConsumption and low torqueMaximum power and torque
Optimised zone1,200–2,500 rpm, part loadFull load
Consumption−5–12%Same or slightly lower if not used
For whomFleets, delivery, trucksPrivate customers, performance

For a delivery van, Eco. For the same van used as a mountain camper, an intermediate. We adjust to the use.

FAQ

Frequently asked questions

How much does it really save?

Between 5 and 12% on real routes, measured with the same driver and route. More on loaded and urban vehicles.

Do I lose power with Eco?

No; you gain low-rev torque. Peak power rises slightly or stays.

Do you do Eco on trucks and buses?

Yes, on Euro 5 and Euro 6 from the main brands, by file or with a visit to the fleet base.

Do you provide a report for the fleet manager?

Yes, with before-and-after measurements and annual saving estimate.

Contact

No-obligation quote for Eco: fuel saving

Tell us the vehicle, engine, ECU and what you want to achieve. We reply during support hours with a fixed price and lead time.

Request a quote

Data controller: ASF Motors SC (ASF Tech). Purpose: to answer your quote request. We do not share your data. You can exercise your rights as explained in the privacy policy.

Last updated: